A concentrated and high pressure stream of water. Pressing the button a second time starts a nozzle oscillation, moving the nozzle back and forth repetitively.
A one-touch program that starts with full nozzle extension, Water Pressure set to low, Front Wash for one minute, Nozzle Oscillation for 30 seconds, then Pulse for 30 seconds.
Can be activated during a wash cycle to start a repeated increase and decrease in water pressure.
Sitz Bath Mode
Switches the water pressure to the lowest level. Start a wash and press the Nozzle Cleaning button. Sitz Bath mode will run for five minutes. To cancel the Sitz Bath mode, press the Nozzle Cleaning button again.
When activated, the bidet essentially powers down: the night light, the side arm lights, the seat heater and the water heater will turn off. To activate Sleep Mode, press and hold the Stop button for four seconds and the unit will power down. To awaken the from Sleep Mode, press the Stop, Front, or Strong button.
Factory Default Reset
To reset the Factory Default settings, press and hold the Stop button for ten seconds. A beep will sound at two seconds indicating the beginning of the reset process and another beep will sound at four seconds indicating the reset is activated.
Automatic Tank Draining
To prevent stagnation, water in the warm water storage tank can be set to drain and refill itself if the seat hasn’t been used in 48 hours. To program this feature, press Stop and Water Temp at the same time for four seconds.